Speed and feed charts
A library organised by material, tool diameter and geometry. Published values must remain traceable and versioned.
Open
MatchMyTools
Technical resources
Calculators, compatibility tools, safety guides and versioned workshop documents.
Choose a resource
Each page states its scope, limits and update status.
Material and tool compatibility
Compare tool families by machine, material, operation and desired finish.
OpenSafety guides
Pre-cut checks, maximum speed, workholding, extraction, PPE and immediate stop conditions.
OpenTechnical calculators
RPM, feed rate, chip load, drilling, discs, blades, abrasives, ER11/ER20 toolholding and conversions.
OpenMaterials library
Risks, chip evacuation, cooling and checks for wood, panels, plastics, metals and masonry.
Open
Tool geometries
Upcut, downcut, compression, O-flute, V-bits, drills, blades and discs: purpose and limits.
OpenMachine and accessory compatibility
Check collet, chuck, shank, bore, flanges, diameter and maximum speed before mounting.
OpenCutting and drilling troubleshooting
Burning, melting, tear-out, burrs, vibration, drill binding and disc wear.
OpenTechnical glossary
Bilingual definitions of the essential terms used in the selector and guides.
OpenPre-purchase checklist
Check dimensions, speed, mounting, material, depth and manufacturer data before ordering.
OpenEbooks and technical sheets
Downloadable guides, checklists and setup sheets for practical workshop use.
OpenSafety firstManufacturer limits always override general guidance.
Versioned informationScope and revision status remain visible.
Starting points onlyTest progressively on scrap material.