Choose the Accessory for the Router Base
| Configuration | DEWALT accessory | Status |
|---|---|---|
| DWP611 / DWP611PK with fixed base | DNP615 | Manufacturer compatibility |
| DWP611PK with plunge base | DNP616 | Separate part |
| Other router or base | Do not assume compatibility | Verify first |
The router model alone is not enough: identify the base actually installed. The DNP615 and DNP616 use different geometries and should not be interchanged merely because they belong to the same compact-router family.
Connect the Hose Without Assuming a Size
The official DNP615 page describes easy vacuum hook-up but does not give a precise size in the reviewed published data. MatchMyTools therefore does not label any nominal hose as a direct fit for this configuration. Measure the cuff ID and OD, check taper and available depth, then use a fitting identified for your system.
Verify the Installation
- Unplug the router before removing or installing the base.
- Install the DNP615 only on the intended fixed base.
- Verify that the accessory does not reduce required visibility or travel.
- Support the hose so it does not pull on the router during cutting.
Frequently Asked Questions
Which base is the DNP615 designed for?
DEWALT specifies it for DWP611 and DWP611PK fixed-base units.
Does the DNP615 fit the plunge base?
No. DEWALT’s part for the plunge base is the DNP616.
Which hose size fits the DNP615?
The reviewed DNP615 page does not publish a precise size. Verify the actual cuff and fitting dimensions.
Technical Sources
Unplug the router before installation. Keep the intended guards, verify base clamping and prevent the hose from interfering with the bit, workpiece or guidance system.